Emaxx Poseidon 1717 brushless motor mount 3903/3905/3908 castle 2200kv,2650kv
Poseidon 1717 / 2200kv or any similar size brushless motor. Will also fit Castle motor. This mount was made so you would have more gearing options in the 3903 / 3905 / 3908 Emaxx. Can be installed with the motor to the front of the truck (see pics) but will need long motor wires depending on where you install your esc. Can also be installed with motor and tranny facing the rear of the truck but chassis has to be trimmed to allow you to fit the transmission in the chassis in reverse ( see pics also), you can see how much to trim in the picture. I don't think this will work on the aftermarket chassis only stock chassis. Spur gears over 58t wont fit because the will hit the battery unless you use the one side for you battery and in that case the chassis will need to be cut a little more to fit gears bigger then 65t. This mount is great if you want those high speed runs or just more gearing options. I have mine geared at 56/28 mod.8 or 32p but you can also use mod 1 gears for those speed runs. This mount is 3 pieces, tranny plate, motor plate and esc plate all the screws, nuts and standoffs. Works with the Castle Mamba Monster esc. MOTOR MOUNT PLATES AND ALL HARDWARE TO INSTALL. TRUCK,MOTOR OR ESC NOT INCLUDED. Cut from raw 6061 aluminum and not polished. Will be sand blasted to a matte finish.
Out of stock